| Product: | Toggle switch |
| Manufacturer: | Nidec Copal |
| Features: | 1. Contacts : Silver or gold. |
| 2. Epoxy resin case : UL94V-0 self-extinguishing epoxy. | |
| 3. Actuator styles : Over 30 actuator variations. | |
| 4. Insulation between terminal and ground : 4 mm minimum. | |
| 5. Prevention of flux entry The epoxy resin seal on bottom of the switch helps prevent the entry of solder and flux. | |
| 6. Insulation barrier : Insulation barrier design between poles helps prevent short-circuiting between poles ensuring high reliability. | |
| 7. UL Recognized product File No.E432759 | |
| 8. CSA Certified product File No.LR38341 |
Contact
| Specifications | |
| Packaging method: | Bag |
| Installation type: | Panel |
| Operating temp: | －30℃～85℃ |
| Ampacity: | Silver Contact: 6A/3A/4A Gold Contact: 6A/3A /25mA |
| Rated voltage: | Silver Contact: AC125V/AC250V /DC30V Gold Contact: AC125V/AC250V/DC20V |
| Size (mm) (L*W*H): |
8x13x9 13x13x9 17.8x13x11.3 22.6x13x11.3 |
| note | For further information, please contact:+886-3-4266335 |
| Additional info | |
| Terminal type: | Soldering/Through hole，Right angle/Through hole，Right angle，Vertical |
| Circuit: | 1~4PDT |
| Feature: |
Circle shape |
| Rating Max.: | Silver Contact:AC125V 6A AC250V 3A DC30V 4A Gold Contact:AC125V 6A AC250V 3A DC20V 25mA |
|---|---|
| Initial contact resistance: | Silver Contact:10mΩ Max. （DC2～4V 1A） Gold Contact:20mΩ Max. （AC200μV 1.5mA） |
| Initial dielectric strength: | AC1500V 1minute |
| Initial insulation resistance: | 1000MΩMin. （ DC500V） |
| Electrical life: | Alternate type:50,000cycles Momentary type:25,000cycles |
| Operating temperature range: | －30～＋85℃ |
| Storage temperature range: | －40～＋85℃ |
Soldering Specifications
- Manual soldering/Device ：Solder iron ①420℃ Max. 3 sec. Max.
- Auto soldering/275℃ Max. 6 sec. Max.
- The above-stated soldering conditions shall apply only to switches with straight terminals. Auto soldering is not possible with right-angle terminals. Switches with right-angle terminals should be soldered manually according to the conditions specifi ed in (1) above.
- When soldering two or more terminals to the common land, use the solder resist to isolate the terminals.
Flux Cleaning
- Solvent : Fluorine or Alcohol type.
- 8A/B/C/D/E/F/J series are not washable. To wash the PC board, clean the soldering surface of the PC board with a brush so that the switch is not exposed to the cleaning solution.
- Cleaning after soldering should be done after the terminal temperature falls to 90℃ or below, or after leaving the switch for fi ve minutes or longer at room temperature.
Mounting
- Do not bend the terminals before mounting the switch on the PC board.
- After mounting the switch, do not place the device in such a way that the device weight will be applied on to the actuator of the switch.
- For switches with straight terminals, solder the switch on the PC board after fi xing the switch on the panel with a nut.
Back