| Product: | Toggle switch |
| Manufacturer: | Nidec Copal |
| Features: | 1. Twin-contact clip mechanism for high reliability. |
| 2. Process sealed structure. |
Contact
| Specifications | |
| Packaging method: | Tray |
| Installation type: | Through hole, right angle |
| Operating temp: | -20℃ ～ +85℃ |
| Ampacity: | Max.： 50mA Min.：1μA |
| Rated voltage: | Max.：AC/DC48V Min.：AC/DC20mV |
| Size (mm) (L*W*H): |
13.1X10.9X10 |
| note | For further information, please contact:+886-3-4266335 |
| Additional info | |
| Function: | ON-OFF-ON，ON-ON |
| Actuator: | Locking lever |
| Features: | Sealed，UL , ATLE4: Locking lever type |
| Circuit: | 2PDT/4PDT |
ELECTRICAL CHARACTERISTICS
| Rating: | Max.：50mA 60VAC/DC Min.：1μA 20mVAC/DCA UL：48VAC/DC 50mA:AC/DC20mV 1μA |
|---|---|
| Initial contact resistance: | 100mΩ max.(1.5mA 200μVAC) |
| Dielectric strength: | 500VAC 1 minute |
| Insulation resistance: | 500MΩ min. (500VDC) |
| Electrical life: | 10,000 cycles at max. rating |
| Operating temperature range: | -20℃～＋85℃ |
| Storage temperature range: | -40℃～＋85℃ |
Soldering Specifications |
|
Flux Cleaning: |
(1) Solvent : Fluorine or Alcohol type. (2) Cleaning after soldering should be done after the terminal temperature falls to 90℃ or below, or after leaving the switch for five minutes or longer at room temperature. |
| Soldering: | (1) Manual Soldering Device ： Soldering iron 380℃, Max.; 3 seconds, Max. (2) Auto Soldering Device ： Jet wave type or dip type 275℃, Max.; 6 seconds, Max. (3) Pre-heating should be done at temperatures ranging from 80℃ to 120℃ and within 120 seconds. |
| Mounting: | (1) Do not bend the terminal pins before mounting the switch on the PC board. (2) After mounting the switch, do not place the device in such a way that the device weight will be applied on to the actuator of the switch. (3) Do not apply load exceeding 12.7 N to the actuator. |
Back